JG Edelbrock Performerx Turbo Kit Photos

Make sure you route the hose around the turbo exhaust elbow. Do not look directly at the camera.
Make sure you route the hose around the turbo exhaust elbow. Do not look directly at the c
Install the turbocharge pipe to the outlet of the compressor housing. Hex-head bolts are provided. This will also require you to be under the car.
Install the turbocharge pipe to the outlet of the compressor housing. Hex-head bolts are p
Bolt the turbo intake pipe into place. Use the provided bracket and air cleaner.

You will need to separate the intake air temperature sensor from the wire harness so it can reach the new intake pipe.
You will need to separate the intake air temperature sensor from the wire harness so it ca
Use a razor blade to cut through the loom, making sure you don't damage any wires. Plug the sensor into the intake pipe; rewrap the wires with electrical tape.
Use a razor blade to cut through the loom, making sure you don't damage any wires. Plug th
Install the intercooler piping using the provided clamps and hoses.

Some pieces have brackets integrated so you can secure the piping to the chassis of the car.
Some pieces have brackets integrated so you can secure the piping to the chassis of the ca
The new intake manifold is much larger than the factory unit and has a set of four secondary injectors already installed on the underside. As you can see, the stock intake manifold is really puny and can use a good trip to the trash can.
The new intake manifold is much larger than the factory unit and has a set of four seconda
(See Previous Image For Caption)

Transfer all the sensors over from the old manifold to the new one. Don't forget to install the throttle body. The kit comes with new nipple fittings to replace all the ones that are machine-pressed into the stock manifold.
Transfer all the sensors over from the old manifold to the new one. Don't forget to instal
(See Previous Image For Caption)
This system requires the use of your stock injectors.

Swap those injectors and the fuel rail over to the new manifold.
When you're done preparing the intake manifold, the top and bottom sides should look something like this. If you're missing pieces, you better check your old manifold again.
When you're done preparing the intake manifold, the top and bottom sides should look somet
(See Previous Image For Caption)

Use a new gasket and install the new intake manifold. Make sure the gasket fits properly; if need be, trim to match it to the parts. Tighten the 12mm nuts and plug in all the sensors and hoses where they belong.
Use a new gasket and install the new intake manifold. Make sure the gasket fits properly;
(See Previous Image For Caption)
Run the harness for the piggyback computer through the hole in the firewall. Aren't you glad that you took the battery out when we told you to?
Run the harness for the piggyback computer through the hole in the firewall. Aren't you gl

Now find the ECU and harness on the kick panel of the passenger side and install the piggyback unit.
Now find the ECU and harness on the kick panel of the passenger side and install the piggy
You can either cut fenderwell plastic linings to fit the intercooler piping or remove them completely. This will be necessary on both sides of the car.
You can either cut fenderwell plastic linings to fit the intercooler piping or remove them
Bolt on the new downpipe, fill up all your fluids again, and you're good to go. Pat yourself on the back and grab your ass repeatedly.
Bolt on the new downpipe, fill up all your fluids again, and you're good to go. Pat yourse