31. At the top, run the pipe to the throttle body using the new silicone boot and hose clamps.31. At the top, run the pipe to the throttle body using the new silicone boot and hose cla 32. Once you're sure that everything is good to go, tighten down all the hose clamps with an 8mm socket or flathead screwdriver.32. Once you're sure that everything is good to go, tighten down all the hose clamps with 33. Don't forget that breather hose you took off earlier or else your car will idle funny. 34. Now you can go and put the horn bells back, tightening them down with a 12mm socket. 35. Line up the bumper, which will no longer fit, and measure where you need to cut so that it clears the new mammoth intercooler.35. Line up the bumper, which will no longer fit, and measure where you need to cut so tha 36. Here's what the GReddy Spec M front-mount intercooler looks like before it's covered up by the bumper.36. Here's what the GReddy Spec M front-mount intercooler looks like before it's covered u 37. Now you can put that lame bumper back on. We only replaced three out of five bolts on each side to make it easier to take off next time. Install the smaller battery, start the car and drive around to make sure you did everything right.37. Now you can put that lame bumper back on. We only replaced three out of five bolts on CONNECT Design Motorsports Engineering 626-968-5147 www.dme-power.com Phase 2 Motortrend GReddy « | 1 | 2 | 3 | View Full Article By Ricky Chu Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
