Defi-Link Display - Defi Jam

16. The wires weren't long enough so they were extended to run through the car.

17. You'll need a power and ground wire to get the units working, so take out the glove box and start searching for them with a voltmeter. Splice into the proper wires and then solder them into place.

18. On the back of the Control Unit, plug the harnesses into the proper slots.

19. Refill your radiator fluid. You could use a funnel, but Yamz did it ghetto-style with a rolled up piece of paper.

20. Now refill your engine with oil. If you're a baller, you can use the Motul. If not, then use whatever you can afford.

21. Surprise, surprise. When the ignition is turned off, the display is black. Either that, or you seriously messed up the wiring.

22. The display can show two readouts at a time. Here are the oil and water temperature readings.

23. Hit the button and you can toggle to the pressure readouts. Uh-oh, 0psi oil pressure. Time to worry. Just kidding. The car is off.