The axle nut. Besides an elephant's, quite possibly the largest nut found on land. Remove the 30mm monster and washer.The axle nut. Besides an elephant's, quite possibly the largest nut found on land. Remove With the axle nut gone, the stock four-lug hub should come off with relative ease. It's a good idea to coat the inside of the hub with bearing grease prior to installation. Slide the shiny new five-lug Ichiba hub on and slide the keyed washer and axle nut back on.Slide the shiny new five-lug Ichiba hub on and slide the keyed washer and axle nut back on Tighten the axle nut using a torque wrench to 150 lb-ft. Replace the cotter pin and bend the ends. Remove any oils or grease on the new Z32 rotor with brake cleaner and fit it over your new five-lug. Don't forget the cap.Remove any oils or grease on the new Z32 rotor with brake cleaner and fit it over your new Slide the new Circuit Sports brake lines into the hard line mount and wedge in the clip. Tighten the 10mm nut. « | 1 | 2 | 3 | » | View Full Article By Mr. K Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!