Install the water hose and belt 6PK1700. You're going to relocate some more factory parts, including the horn and power steering cooler. This will make room for the traction oil tank and HKS oil cooler assembly, which is the most intensive portion of the install. You will also mount the HKS intercooler tank using the supplied hardware and install the lower intercooler piping.You're going to relocate some more factory parts, including the horn and power steering co Install the pressure sender and vacuum hose; secure it by mounting it to the power steering fluid reservoir tank bracket.Install the pressure sender and vacuum hose; secure it by mounting it to the power steerin Time to set up the wiring for the F-CON. Start by removing the battery cover and top cowl cover on the passenger side of the engine bay. Use HKS' instructions to prep the wiring harness; it'll also be fed through this area to the firewall where the F-CON will be connected from inside the passenger cabin underneath the passenger footwell.Time to set up the wiring for the F-CON. Start by removing the battery cover and top cowl Install the upper intercooler pipe; it's the shiniest one of the bunch. Add the HKS traction oil (provided) to the traction oil tank. This must be done before starting the engine; starting the engine without the traction oil can damage the supercharger assembly.Add the HKS traction oil (provided) to the traction oil tank. This must be done before sta Install the HKS air filter; make sure it does not interfere with the chassis or other surrounding parts (it took some work to make it fit properly). Trim the air cleaner duct so that it won't hit the air filter.Install the HKS air filter; make sure it does not interfere with the chassis or other surr Install the last belt, 7PK1060, but check all of your belts' tension a couple hours after the installation is complete. Adjust as needed to match HKS' tension specs. Reinstall all of the factory parts from step #1 (don't forget to connect your battery!). Install the one-way check valve into the rubber vacuum hose that runs between the intake manifold and the EVAP control solenoid valve. Run down HKS' check list before firing up your blown VQ; you'll be good to go after you have!Install the last belt, 7PK1060, but check all of your belts' tension a couple hours after Without even flinching, the GT Supercharger adds 50 horsepower to the VQ without any need to tune the F-CON -HKS already does the hard part for you by pre-setting/tuning the unit. After adding a dual Hiper exhaust, the car picked up another 18 hp. Significant gains can be seen in the torque curve, which nearly shot up 80-percent after the exhaust was installed.Without even flinching, the GT Supercharger adds 50 horsepower to the VQ without any need CONNECT HKS USA 13401 S. Main St. Los Angeles CA 90061 3-10/-763-9600 www.hksusa.com « | 1 | 2 | 3 | View Full Article By Jonathan Wong Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
