The good thing about HKS' GT supercharger kit is that it's all bolt-on and tuned, ready to go. Since the install requires you to work with your car's fuel components, it's a necessity for you to disconnect your battery before touching anything. Working in a well-ventilated area would also be helpful.The good thing about HKS' GT supercharger kit is that it's all bolt-on and tuned, ready to There's going to be a lot of removing/relocating of factory parts and you'll start by removing the front bumper, strut tower bar, air box, mass air flow (MAF) sensor and bumper reinforcement. Do this with some friends to save some time.There's going to be a lot of removing/relocating of factory parts and you'll start by remo You'll change the fuel pump next and you can access it by looking under the rear cover behind the passenger seat. Cover the area with some shop rags in the event you spill some gas and carefully remove the factory fuel pump. Install the HKS fuel pump in the reverse order of removal.You'll change the fuel pump next and you can access it by looking under the rear cover beh More fuel is required when using a supercharger system, so HKS provides additional injectors, which can be installed after removing the intake plenum cover. The injectors must be pre-assembled to the intake plenum.More fuel is required when using a supercharger system, so HKS provides additional injecto Add the fuel line adapter between the fuel feed hose and fuel sub tube. Install the fuel rail assembly and secure the tabs on the mounting clips facing outward. These must be facing outward; otherwise fuel can hit it.Add the fuel line adapter between the fuel feed hose and fuel sub tube. Install the fuel r Assemble the GT Supercharger unit per HKS' detailed instructions, taking note of the tensioner pulley installation order (tensioner pulley #1 is used here). Install the relief valve and your MAF sensor to the provided HKS piping.Assemble the GT Supercharger unit per HKS' detailed instructions, taking note of the tensi Remove these 10 stock bolts as shown; this is where the GT Supercharger will mount to. Replace the power steering pump bracket bolt with the supplied bolt; it'll give the supercharger more clearance to fit.Remove these 10 stock bolts as shown; this is where the GT Supercharger will mount to. Rep Modify the factory A/C pipe to avoid contact with the pipe we discussed in step #6. You'll use a supplied bracket to relocate the A/C pipe.Modify the factory A/C pipe to avoid contact with the pipe we discussed in step #6. You'll Attach the GT Supercharger assembly onto the engine, then install idler pulley #2 onto the bearing assembly.Attach the GT Supercharger assembly onto the engine, then install idler pulley #2 onto the « | 1 | 2 | 3 | » | View Full Article By Jonathan Wong Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
